User's Manual

CE870 Card Personalization System Installation and User Guide 59
Chapter 6: System
Maintenance
The CE870 Card Personalization System is designed
to be easy to maintain. System operators should be
instructed in routine maintence tasks such as
running a cleaning card. The cleaning card process
removes dirt and particles from inside the system.
This section includes the following:
• Clean the Printer
• Clean the Embosser
• Run a Cleaning Card
Clean the Printer
The following steps should be followed to keep the printer component of the
system clean and in good operation.
• Run a cleaning card and replace the cleaning sleeve in the printer component
after every 500 cards processed by the print system.
• Keep the surface and area around the printer clean and free of environmental
contaminates such as dust and moisture.
• Never clean the surface of the printer with abrasive chemicals or cleansers.
• Keep the area around the printer free of obstructions that may limit
ventilation or access to components.
Clean the Embosser
These steps should be followed to keep the embosser component of the system
clean and in good operation.
• Keep the surface and area around the embosser clean and free of
environmental contaminates such as dust and moisture.
• Never clean the surface of the embosser with abrasive chemicals or cleansers.
• Keep the area around the embosser free of obstructions that may limit
ventilation or access to components.