User's Manual
Table Of Contents
- Cover
- Contents
- 1 Welcome to the Card Personalization System
- 2 Installation Requirements
- 3 Install the System
- 4 Using the System
- 5 Card Design
- 6 System Maintenance
- 7 Troubleshooting
- Tools for Troubleshooting
- Locating the Issue
- Installation Troubleshooting
- Card Appearance
- Magnetic Stripe
- Card Jam
- Messages and Conditions
- Respond to Messages
- Printer Component Messages (100-124)
- 100: Request not supported
- 101: Job could not complete
- 102: Card not in position
- 103: Printer problem
- 104: Critical problem
- 105: Magstripe data error
- 106: Magstripe data not found
- 107: Magstripe read data error
- 108: Magstripe read no data
- 111: Card not picked
- 112: Hopper Empty
- 113: Close cover to continue
- 114: Cover opened during job
- 116: Magstripe not available
- 117: Reader not available
- 120: User paused the printer
- 122: Magnetic stripe format problem
- 123: Insert new card then continue
- 124: Insert same card then continue
- Embosser Component Messages (125-151)
- 125: Emboss critical issue
- 126: Emboss format issue
- 127: Emboss transport error
- 128: Embosser card jam
- 129: Embosser topper jam
- 130: Embosser card entry jam
- 131: Embosser card exit jam
- 132: Embosser card stack full
- 133: Embosser card reject full
- 135: Indent ribbon supplies out
- 136: Indent ribbon break
- 137: Embosser wheel error
- 138: Embosser indent error
- 139: Lost card, open emboss cover
- 140: Embosser not available
- 141: Close emboss cover
- 142: Emboss cover error
- 143: Topper ribbon problem
- 144: Topper ribbon out
- 145: Topper ribbon type problem
- 146: Topper ribbon support err.
- 147: Topper ribbon no tag found
- 149: Option not installed
- Printer Component Messages (100-124)
- 8 Supplies and Parts
- 9 Legal Notices
CE870 Card Personalization System Installation and User Guide 33
User Button and Light
The printer has a USER button with a boarder of light that indicates the system
status.
• Press the U
SER button to suspend the printer when it displays Ready.
• Press the U
SER button to clear a message.
• Press the USER button for 2 seconds or more to clear all messages.
• The U
SER light indicates whether the system is ready, busy, or not ready.
Down Arrow, Up Arrow, and Enter Keys
Use the arrow keys to move through the LCD menu system and the ENTER key to
make a selection. See Use the LCD Menus for details.
Off System is off.
Green System is ready or suspended.
Flashing green System is busy. The light flashes slowly
(every 2 seconds).
or
The system has a hardware error
concerning the embosser. The light
flashes quickly (every 1/2 second).
Amber The system is not ready.
The P
OWER button was pressed to turn
the printer off.
Flashing Amber The system has a problem. The light
flashes at a medium rate (every second).
or
The system has a hardware error
concerning the printer. The light flashes
quickly (every 1/2 second).