User's Manual
Table Of Contents
- Cover
- Contents
- 1 Welcome to the Card Personalization System
- 2 Installation Requirements
- 3 Install the System
- 4 Using the System
- 5 Card Design
- 6 System Maintenance
- 7 Troubleshooting
- Tools for Troubleshooting
- Locating the Issue
- Installation Troubleshooting
- Card Appearance
- Magnetic Stripe
- Card Jam
- Messages and Conditions
- Respond to Messages
- Printer Component Messages (100-124)
- 100: Request not supported
- 101: Job could not complete
- 102: Card not in position
- 103: Printer problem
- 104: Critical problem
- 105: Magstripe data error
- 106: Magstripe data not found
- 107: Magstripe read data error
- 108: Magstripe read no data
- 111: Card not picked
- 112: Hopper Empty
- 113: Close cover to continue
- 114: Cover opened during job
- 116: Magstripe not available
- 117: Reader not available
- 120: User paused the printer
- 122: Magnetic stripe format problem
- 123: Insert new card then continue
- 124: Insert same card then continue
- Embosser Component Messages (125-151)
- 125: Emboss critical issue
- 126: Emboss format issue
- 127: Emboss transport error
- 128: Embosser card jam
- 129: Embosser topper jam
- 130: Embosser card entry jam
- 131: Embosser card exit jam
- 132: Embosser card stack full
- 133: Embosser card reject full
- 135: Indent ribbon supplies out
- 136: Indent ribbon break
- 137: Embosser wheel error
- 138: Embosser indent error
- 139: Lost card, open emboss cover
- 140: Embosser not available
- 141: Close emboss cover
- 142: Emboss cover error
- 143: Topper ribbon problem
- 144: Topper ribbon out
- 145: Topper ribbon type problem
- 146: Topper ribbon support err.
- 147: Topper ribbon no tag found
- 149: Option not installed
- Printer Component Messages (100-124)
- 8 Supplies and Parts
- 9 Legal Notices
CE870 Card Personalization System Installation and User Guide 29
Chapter 4: Using the System
This section details information about how the card travels
through the system, how the data is received and processed, and
how to use the features of the system such as the optional Touch
Screen and the printer’s Front Panel.
This section describes how to:
• Process Cards
• Use the Touch Screen
• Use the Front Panel
• Use the LCD Menus
• Use the Printer Manager
Process Cards
The software used to enter card data is called a server-based print director. In
most cases, this is a custom application developed specifically for your
organization. The software is designed to send card data to the card
personalization system.
The data is received and the card can be accessed and produced from the system’s
optional Touch Screen. The Touch Screen uses the Datacard Personalization
Manager (DPM) to produce the card. With DPM, you can select which hopper to
pick from, and preview your print job before producing a card.
To access the features of the DPM and to produce a card, you will need to sign in
to the Touch Screen using your unique ID and authentication number.