User's Manual
Table Of Contents
- Cover
- Contents
- 1 Welcome to the Card Personalization System
- 2 Installation Requirements
- 3 Install the System
- 4 Using the System
- 5 Card Design
- 6 System Maintenance
- 7 Troubleshooting
- Tools for Troubleshooting
- Locating the Issue
- Installation Troubleshooting
- Card Appearance
- Magnetic Stripe
- Card Jam
- Messages and Conditions
- Respond to Messages
- Printer Component Messages (100-124)
- 100: Request not supported
- 101: Job could not complete
- 102: Card not in position
- 103: Printer problem
- 104: Critical problem
- 105: Magstripe data error
- 106: Magstripe data not found
- 107: Magstripe read data error
- 108: Magstripe read no data
- 111: Card not picked
- 112: Hopper Empty
- 113: Close cover to continue
- 114: Cover opened during job
- 116: Magstripe not available
- 117: Reader not available
- 120: User paused the printer
- 122: Magnetic stripe format problem
- 123: Insert new card then continue
- 124: Insert same card then continue
- Embosser Component Messages (125-151)
- 125: Emboss critical issue
- 126: Emboss format issue
- 127: Emboss transport error
- 128: Embosser card jam
- 129: Embosser topper jam
- 130: Embosser card entry jam
- 131: Embosser card exit jam
- 132: Embosser card stack full
- 133: Embosser card reject full
- 135: Indent ribbon supplies out
- 136: Indent ribbon break
- 137: Embosser wheel error
- 138: Embosser indent error
- 139: Lost card, open emboss cover
- 140: Embosser not available
- 141: Close emboss cover
- 142: Emboss cover error
- 143: Topper ribbon problem
- 144: Topper ribbon out
- 145: Topper ribbon type problem
- 146: Topper ribbon support err.
- 147: Topper ribbon no tag found
- 149: Option not installed
- Printer Component Messages (100-124)
- 8 Supplies and Parts
- 9 Legal Notices
26 Install the System
Connect Power Cables
1. Connect the printer power cable into the printer and into the power supply.
2. Connect the power supply cord into the power outlet.
3. Connect the embosser power cable into the embosser and into the power
supply.
4. Connect the power supply cord into the power outlet.