User's Manual

CE870 Card Personalization System Installation and User Guide 21
Load Topping Foil Cartridge
1. Unlock and open the embosser supplies access door and remove the topping
foil cartridge. The topping foil cartridge is on the left. See Inside the
Embosser for more information.
2. Push the full roll of ribbon onto the
spindle on the right until it snaps
securely into place.
3. Route the ribbon around the
ribbon guides as shown.
4. Push the empty take-up spool onto
the spindle on the left (spindle
with the black gear) until it snaps
securely into place.
5. Turn the take-up spool one full
turn counterclockwise to take up
ribbon slack.
6. Replace the topping foil cartridge.
The emboss and indent ribbon cartridges are not interchangeable; they fit
only into the designated cartridge area.
A. Hold the cartridge by its handle.
B. Align the top of the cartridge with the guides inside the embosser.
C. Slide the cartridge in until it stops.
7. Close and lock the embosser supplies access door.