User's Manual

20 Install the System
Load Supplies
Embossing supplies include topping foil and indent ribbon. The topping foil is
applied to the embossed characters and can be applied to up to five lines of
characters. The indent ribbon is used to apply black (or white) color to a single
line of indented characters. The printer supplies include a cleaning sleeve.
Load Indent Ribbon Cartridge
1. Unlock and open the embosser supplies access door and remove the cartridge
from the embosser. The indent ribbon cartridge is on the right. See Inside the
Embosser for more information.
2. Push the full roll of indent
ribbon onto the spindle on
the right until it snaps
securely into place.
3. Route the ribbon around the
ribbon guides as shown.
4. Push the empty take-up
spool onto the spindle on the
left until it snaps securely
into place.
5. Turn the take-up spool one
full turn counterclockwise to
take up ribbon slack.
6. Replace the indent ribbon cartridge.
The emboss and indent ribbon cartridges
are not interchangeable; they fit only into
the designated cartridge area.
A. Hold the cartridge by its handle.
B. Align the cartridge with the guides
inside the embosser.
C. Slide the cartridge in until it stops.
7. Close and lock the embosser supplies
access door.