User's Manual

18 Install the System
Secure the System
The embosser includes bolt-down openings for securing the system to its
mounting surface. Choose a location in which to install the system following the
requirements shown in Site Requirements.
1. Unlock and open the embosser
supplies access door.
2. Remove the topping foil and
optional indent ribbon cartridges
and set aside.
3. Bolt the embosser to the work
surface.
You need the following supplies:
• Embosser Bolt-Down
Specification Sheet (Part No.
539999-001).
• Two 1/4 inch Bolts.
The length of the bolts depends on the thickness of the mounting surface.
Bolt length minimum of surface thickness + ¾ inch. Bolt length maximum
of surface thickness +1¼ inch.
• Two 5/8 inch outer diameter Washers.
• Two 1/4 inch Nuts.
Plastic locking nuts are recommended.
A. Drill mounting holes in the mounting surface following the dimensions
and requirements shown on the Embosser Bolt-Down Specification Sheet.
B. Insert the bolts.
i. Place a flat washer on each of the bolts.
ii. Insert the bolts into the mounting holes inside the embosser.
iii. Align the bolts with the holes in the embosser.
C. Secure the embosser using washers and nuts on the inside of the
embosser.
4. Replace the topping foil and indent ribbon cartridges.
5. Close and lock the embosser supplies access door.
Indent Ribbon
Cartridge
Topping Foil
Cartridge
Embosser Supplies
Access Door