User's Manual
Table Of Contents
- Cover
- Contents
- 1 Welcome to the Card Personalization System
- 2 Installation Requirements
- 3 Install the System
- 4 Using the System
- 5 Card Design
- 6 System Maintenance
- 7 Troubleshooting
- Tools for Troubleshooting
- Locating the Issue
- Installation Troubleshooting
- Card Appearance
- Magnetic Stripe
- Card Jam
- Messages and Conditions
- Respond to Messages
- Printer Component Messages (100-124)
- 100: Request not supported
- 101: Job could not complete
- 102: Card not in position
- 103: Printer problem
- 104: Critical problem
- 105: Magstripe data error
- 106: Magstripe data not found
- 107: Magstripe read data error
- 108: Magstripe read no data
- 111: Card not picked
- 112: Hopper Empty
- 113: Close cover to continue
- 114: Cover opened during job
- 116: Magstripe not available
- 117: Reader not available
- 120: User paused the printer
- 122: Magnetic stripe format problem
- 123: Insert new card then continue
- 124: Insert same card then continue
- Embosser Component Messages (125-151)
- 125: Emboss critical issue
- 126: Emboss format issue
- 127: Emboss transport error
- 128: Embosser card jam
- 129: Embosser topper jam
- 130: Embosser card entry jam
- 131: Embosser card exit jam
- 132: Embosser card stack full
- 133: Embosser card reject full
- 135: Indent ribbon supplies out
- 136: Indent ribbon break
- 137: Embosser wheel error
- 138: Embosser indent error
- 139: Lost card, open emboss cover
- 140: Embosser not available
- 141: Close emboss cover
- 142: Emboss cover error
- 143: Topper ribbon problem
- 144: Topper ribbon out
- 145: Topper ribbon type problem
- 146: Topper ribbon support err.
- 147: Topper ribbon no tag found
- 149: Option not installed
- Printer Component Messages (100-124)
- 8 Supplies and Parts
- 9 Legal Notices
12 Welcome to the Card Personalization System
The embosser configuration label shows the embosser name, configuration, date
and country of assembly.
The embosser configuration label provides information that is useful when
requesting service. It can also help you know which components are installed. If
components are installed by the dealer or sales group, the information for those
items should be on the label.
How To Topics
Select a link from the topics below to quickly access common user topics on how
to use the CE870 Card Personalization System.
• Select Use the Touch Screen for information on how to open printer
manager.
• Select LCD Panel for information on how to view and use the printer LCD
menus.
• Select Respond to Messages for information on how to respond to messages
that appear on the printer LCD display.
• Select Run Test Card for information on how to print a test card and verify
system operation.
• Select Run a Cleaning Card for information on how to run a cleaning card as
recommended after every 500 cards are produced.
• Select Load Cards in Hopper for information on how to load cards into the
multi-card hopper.
• Select Load Indent Ribbon Cartridge for information on how to replace
indent ribbon inside the embosser.
• Select Load Topping Foil Cartridge for information on how to replace
topping foil inside the embosser.