User's Manual

Visit Datacard.com/id for downloads and support.
The design and information contained in these materials in protected by U. S. and international copyright law and/or treaties.
Use the following dimensions to prevent printing in the smart card area.
(The green arrow shows the direction the card travels through the printer.)
A B C D
0.88 in 0.29 in 0.88 in 1.47 in
22.4 mm 7.4 mm 22.4 mm 37.3 mm
Hints & Tips
Blocking typically extends 0.1 inch
beyond the edges of a feature. The
dimensions listed include the extended
blocking region.
Print several cards using your card
design and application to verify that
printing and topcoat are applied as
you intend.
If you do not use the driver or ID
software, you can use the dimensions
provided for smart card and mag
stripe to customize your print and
topcoat areas.
XPS Card Printer Guide
DRAFT
2/22
Datacard Confidential
Page 50
SHORT TERM CONFIDENTIAL