User's Manual
Table Of Contents
Message 115: Wait for print temperature
The printer is not at the correct temperature to print the
card.
Printing the card will resume on its own.
Message 116: Magstripe not available
Look at the "config" area of the label inside of the printer
cover. Does the label show “M” or “J”?
If yes, the printer has a magstripe option that is not
working. Request service.
If no, the printer does not have a magstripe option.
To print the card without magstripe, remove
magstripe data from the card and send it again.
Close the cover
Hints & Tips
Make sure the ribbon cartridge is
installed and the handle is even with
the edges of the printer.
The card, if it started to print, should
be discarded.
Wait for print temperature
Hints & Tips
The balloon message informs you that
the card requires a few more seconds
to complete.
If this message appears often, move
the printer to a cooler location.
Printer does not have magstripe
Hints & Tips
To remove magstripe data, you might
need to:
Uncheck a box in the
application.
Change the font from "XPS Card
XPS Card Printer Guide
DRAFT
2/22
Datacard Confidential
Page 27
SHORT TERM CONFIDENTIAL