Operation Manual

92
IP2162EN - 2014-04-17
11. Examples of sliding gate applications
When the CS12E control panel is used for sliding automation applications,
the following connections can be made:
Set
Set
Connect the limit switches to the terminal
Connect the limit switches to the terminal
Set
With these settings, if an obstacle is detected while opening, the door wing stops and performs a
disengagement operation whereas during a closing operation, the door wing reopens.
In this configuration, the door wing stops against its respective mechanical closing and opening
end stop. In the event of obstacle detection before the activation of the proximity limit switch while
opening, the door wing stops, performing a disengagement operation; after the proximity limit
switch is activated, the door wing stops against the obstacle.
In the event of obstacle detection during closing and before the activation of the proximity limit
switch, the door wing reopens; after the proximity limit switch is activated, the door wing stops
against the obstacle.
Example 1 - Door wing stops against mechanical end stops (standard setting)
Example 2 - Door wing stops against limit switches (setting with standard limit switches in-
stalled)
Example 3 - Door wing stops against mechanical end stops and reverses motion if an obstacle
is detected
x2 s
- set the correct opening direction:
x2 s
LSW
LSW