Quick Start Guide

IP2012

rev. 2008-12-18

CROSS7E / 8E / 14E - E1A

QUICK REFERENCE

1. ELECTRICAL CONNECTIONS FOR STANDARD INSTALLATION

Before installing the product, carefully read the instructions.

XEL5

XEL2 XEL2

4x0,5 mm²

RG58 (max 10 m)

230~

2x1,5 mm²

GOL4-GOL4C

LAMP

ANT

E1A

CUWV

12 11

011

1 568941

GOL4-GOL4C

3x1,5 mm²

Power supply

PAGE 1
01 TX NO C NC XEL2 XEL5 230~ 2x1,5 mm² RG58 (max 10 m) 4x0,5 mm² 4x0,5 mm² 3x1,5 mm² GOL4-GOL4C ANT L N NC UWV 12 11 0 E1A 12 11 0 1 5 6 8 9 41 XEL2 01 RX 1. ELECTRICAL CONNECTIONS FOR STANDARD INSTALLATION Power supply LAMP Before installing the product, carefully read the instructions. CROSS7E / 8E / 14E - E1A QUICK REFERENCE IP2012 rev.
PAGE 2
. USAGE WITH STOP LIMIT SWITCH CLOSING CYCLE DIP2=OFF OPENING CYCLE A C OPENING CYCLE 1° A Opening limit switch setting 2° C Closing limit switch setting CLOSING CYCLE C CROSS7E / 8E / 14E - E1A QUICK REFERENCE - IP2012 A 2 DIP2=ON 1° A Opening limit switch setting 2° C Closing limit switch setting
PAGE 3
. E1A STANDARD SETTING 3 1 2 4 5 NIO RF DIP2 = ON LEFT OPENING JR3 JR4 JR10 SO 6 4 DIP1 = ON OPENING RADIO MODE ON OFF 1 2 3 4 DIP1 = OFF STEP BY STEP RADIO MODE R1 TC TM JR6 12 0 11 DIP2 = OFF RIGHT OPENING L N N C U W V 12 11 0 1 5 6 8 9 41 4. RADIO ENABLING 1° SIG 2° Push PRG NIO Push CH Led SIG comes on Led SIG flashes 3 times SIG SIG Wait for 10 s PRG JR3 GOL4-GOL4C 5.