User's Manual

ManualsBrandsEntone Technologies ManualsElectronicswireless 802.11bgn module

INTRODUCTION

______________________________________________________________

Congratulations on your purchase of this Wireless LAN (IEEE 802.11n)

module (model name: 39-0008-01-00) which was embedded in Magi

Interactive CATV DVR.

This manual helps to get familiar with the Wireless LAN (IEEE 802.11n)

module. This manual contains detailed specification of this product. Please

keep this manual for future reference.

With a Wireless LAN (IEEE 802.11n) module, a set top box can communicate

with another computer in a wireless way.

Wireless LAN (IEEE 802.11n) can wirelessly transmit and receive data, and

provides users with an access to real-time information anywhere in their

organization. The Wireless LAN (IEEE 802.11n) configuration is suitable for a

small number of users, to full infrastructure networks of thousands of users

that allow roaming around a broad area.

Summary of content (7 pages)

PAGE 1
INTRODUCTION ______________________________________________________________ Congratulations on your purchase of this Wireless LAN (IEEE 802.11n) module (model name: 39-0008-01-00) which was embedded in Magi Interactive CATV DVR. This manual helps to get familiar with the Wireless LAN (IEEE 802.11n) module. This manual contains detailed specification of this product. Please keep this manual for future reference. With a Wireless LAN (IEEE 802.
PAGE 2
Tecsihnical Specifications. RF PRODUCT SPEC Frequency range 2400MHz ~ 2474MHz (FCC Spec.) Channel spacing 5MHz Channel List 2412~2462MHz(FCC SPEC.) Modulation type / CCK, DQPSK, DBPSK for DSSS technology 64QAM, 16QAM, QPSK, BPSK for OFDM L.O. frequency of receiver Data Rate 802.11b: 11.0/ 5.5/ 2.0/ 1.0Mbps 802.11g: 54.0/ 48.0/ 36.0/ 24.0/ 18.0/ 12.0/ 9.0/ 6.0Mbps 802.
PAGE 3
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 4
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
PAGE 5
Industry Canada statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence.
PAGE 6
This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
PAGE 7
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains IC: 5841B-3900080100”.