User's Manual Part 2

T ECHNICAL D OCUMENTATION P ROTECTING P EOPLE AND A SSETS
®
D ATE : 22 M ARCH 2017 | V ERSION : 1.4
55
R ANGER -X5 R ADAR S YSTEM
T
ROUBLESHOOTING
,
M
AINTENANCE
,
AND
C
ALIBRATION
EEC
®
|
C
OMPANY
P
ROPRIETARY
Maintenance:
Contact Enterprise Electronics Corporation should this component require maintenance.
Calibration:
None
2.1.5. Pedestal Enclosure Plate Assembly (Unit 2 A1 A5)
2.1.5.1. 7-Port Ethernet Switch with 1-Fiber Optic Port (Unit 2 A1 A5 A1)
Troubleshooting:
SD-135886-100 Sheet 1 of 3
Sheet 3 of 3
EEC-135886-100 Sheet 2 of 5
Sheet 3 of 5
1. Is the Ethernet Switch receiving power?
YES: Continue to Step 2.
NO: Check the input power using the Schematics.
a. Check the 12VDC Power at Terminal Block (TB1-5, TB1-6, TB1-7).
b. If power is present, proceed to Step 2.
2. If the Ethernet Switch is receiving power but not communicating with any of the units,
then there is likely a connection problem. Replace the Ethernet Switch.
Maintenance:
If the Ethernet Switch does not perform properly, replace the unit.
1. Disconnect all cables from the Ethernet Switch.
2. Use a screwdriver to disconnect from the DIN rail.
3. Pull the Ethernet Switch from the DIN rail.
4. Reinstall the Ethernet Switch in reverse order of steps 1-3.
Calibration:
None
2.1.5.2. Servo Amplifier, 100V, 10A (Unit 2 A1 A5 A2)
Troubleshooting:
SD-135886-100 Sheet 1 of 3
Sheet 2 of 3
Sheet 3 of 3
EEC-135886-100 Sheet 2 of 5