PROGRAMMING YOUR KEYPAD All KEYPADS are shi with the same 5-Digit Primary Code of 3-1-9-7-5. THIS E MUST BE CHANGED BY THE USER TO MAINTAIN SECURITY. Read "CHANGING YOUR PRIMARY CODE" below to change your primary code. To Program the KEYPAD to your Key less Entry Unit, each Digit must be entered within 5-Seconds of the previous Digit, the 9/0 will flash once for each entry.
LOCATING & MAKING CONNECTIONS MANUFACTURER DOOR LOCK TYPES For wiring charts, please visit our website, www. |bstech.com. RED CONSTANT POWER (+12V, key In any position Including off) ‘These wiretaps) are in your vehicle's main ignition shames, usually located on the steering column coming farm the ignition switch. Probe each wire with your test light. The correct wire will show +12V when the Ignition switch Is In these 4 positions (LOCK-ON-OFF-CRANK).
CONNECTING DOOR LOCKS “Type C” Reverse Polarity 14 | REL +12¥ Constant. [al 13 BLACK Ground [| w POWER — BLUE/BLACK Unlock (Motor) DOOR 3 LOCK > S| BROWN/BLACK Unlock (Switch) WERE He TOR = PURPLE wn « [1 sav Ll BLACKCURRANT How Constant >= Cu |GREEN/BLACK Lock (Motor) 2 6 7 |WHITE/BLACK Lock (Switch) Eke] 1 ck |= Yellow Antenna 2 NOTE: Connect the PULE WITH Ke 1s straight z 3 BLACK STRIVE wire from the 3s scrota) +] ape the end to Use to TEV constant power 121d straight.
(Making Connections Continued...) on part #775. Connect the BLACK wire and the BLUE wire to +12V constant fused at 20 amps. If your trunk output tests as a Negative, connect the YELLOW wire from part #775 to the trunk release wire. Connect the WHITE/RED wire from the 14-pin shames to the WHITE wire on part #775. Connect the BLACK wire to +12 constant fused at 5 amps. Connect the BLUE wits to ground.
