User's Manual

INSTALLATION INSTRUCTIONS – Keyless Entry Pad
2 of 2 999KE AR000 II 12/12/05
6. PROGRAMMING A PERSONAL ENTRY CODE
1. Enter the unique factory set code, as indicated to the right.
2. Within five seconds, press and hold 1/2 button. While pressing the 1/2 button, press and hold the 5/6 button for
at least 2 seconds until the 9/0 key flashes twice or the door unlocks. Release both buttons.
3. Within five seconds, enter your desired personal 5-digit code. Each number must be entered within five seconds of each
other.
4. The doors will again lock then unlock to confirm that your personal code has been programmed to the module.
To remove your personal code:
1. Enter the unique factory code, then within five seconds press and hold the 1/2 button, then press and hold the 7/8
button for at least two seconds until the 9/0 key flashes twice or the door will again lock then unlock to confirm
that your personal code has been removed. Release both buttons.
7. ADHERING KEYPAD TO THE VEHICLE
CAUTION
• Do not adhere to moveable glass or windshield.
• The tape is very sticky and will stick fast once contact is made. Use care when positioning keypad. Use masking
tape to mark keypad position and alignment before positioning keypad.
Figure 1
1. This product is designed to attach to your car door, centered
between the door handle and the window sill. See Figure 1.
Mounting surface must be relatively flat. Hold keypad up
to desired mounting surface to confirm that all tape will
contact mounting surface.
2. Clean the vehicle surface where the keypad is to be adhered
with a 50-50 solution of alcohol and water and let dry.
3. Pull the tape tabs off the keypad, center the keypad and
press onto door surface. Be sure to press firmly on all edges
to ensure proper adhesion of the tape.
8. USING THE KEYPAD
1. To unlock the driver’s door, enter your personal 5-digit code or the factory set code. Each number must be pressed within five
seconds of each other.
2. To unlock all doors, press the 3/4 control within three seconds of entering a valid keypad code. Hold down 3/4 control to
lower windows, if equipped.
3. To unlock the trunk, press and hold the 5/6 control within three seconds of entering a valid keypad code. Use the 5/6 to open
or close power lift gate if equipped.
4. To unlock and slide the power sliding doors, press and hold the 7/8 button to open or close the passenger side door within
three seconds of entering a valid keypad code. Press and hold the 9/0 button for the driver side door.
5. To lock all doors, press the 7/8 and the 9/0 keys simultaneously. If all doors are closed, the horn will chirp once; if any door
is ajar, the horn will not chrip. NOTE: Horn may not chirp – see Owner’s Manual.