User's Manual

Locks and Security
before pressing a remote transmitter button, the programming
mode will exit and the procedure will have to be repeated).
• Within 20 seconds, program the remote transmitter by pressing
any button on a transmitter. The doors will lock/unlock to confirm
that the remote transmitter has been programmed.
• Repeat the previous step to program additional remote
transmitters. The doors will lock/unlock to confirm that each
remote transmitter has been programmed.
• When you have completed programming the keypad and the
remote transmitters, turn the ignition to 3 (OFF). Again the doors
will lock/unlock to confirm programming has been completed.
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This device complies with RSS-210 of Industry Canada.
CAUTION: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this equipment.