User's Manual

CHAPTER 8 INTERFACE CONTROL DOCUMENTS (ICD)
APPENDIX A INTERFACE CONTROL DOCUMENTS (ICD)
ISSUE/REVISION DATE: 25 JULY 2007 TECHNICAL MANUAL
ISO 9001:2000 PROPRIETARY
Interface Control Document (ICD) ENTERPRISE ELECTRONICS CORPORATION
Rev No. 5 Page 15 of 21
Issue Date 25 July 2007 UM-130365
Distribution Data Collection
Module (DDC)
THE DATA PRESENTED HEREIN REPRESENTS THE INTELLECTUAL PROPERTY OF ENTERPRISE ELECTRONICS CORPORATION (EEC). THIS DATA MAY NOT BE DISTRIBUTED OR REPRODUCED BY
ANY MEANS WITHOUT THE EXPRESS, WRITTEN CONSENT OF EEC.
Interrupting the boot process
Once we a have a DRCP module connected to a PC and the terminal software configured properly we
should be able to apply power to the module. When the module begins its boot process it outputs a wait-
ing to start message as displayed below .
WAITING TO START
When the waiting to start message appears the A character must be sent to the device to interrupt the
boot process and enter the configuration screen. Once the boot process has been successfully interrupted,
a command prompt will be displayed as shown below. At this point you are ready to change configura-
tion data or download a new application to the module.
MONITOR PROMPT