User's Manual

CHAPTER 8 INTERFACE CONTROL DOCUMENTS (ICD)
APPENDIX A INTERFACE CONTROL DOCUMENTS (ICD)
ISSUE/REVISION DATE: 25 JULY 2007 TECHNICAL MANUAL
ISO 9001:2000 PROPRIETARY
Interface Control Document (ICD) ENTERPRISE ELECTRONICS CORPORATION
Rev No. 5 Page 14 of 21
Issue Date 25 July 2007 UM-130365
Distribution Data Collection
Module (DDC)
THE DATA PRESENTED HEREIN REPRESENTS THE INTELLECTUAL PROPERTY OF ENTERPRISE ELECTRONICS CORPORATION (EEC). THIS DATA MAY NOT BE DISTRIBUTED OR REPRODUCED BY
ANY MEANS WITHOUT THE EXPRESS, WRITTEN CONSENT OF EEC.
Appendix A – Software Loading
Introduction
The DRCP firmware and boot configuration data is stored in an on-board flash memory. This document
is to be used as a guide for configuration and downloading of the application firmware. A processor will
need its configuration, modified when it is a new board without an application and initial configuration
or when a configuration item such as the network configuration needs to be changed. Configuration and
application firmware loading is preformed in the boot monitor console.
Terminal Setup
The firmware and boot configuration data is accessible via the RS-232 console port of each device and
can easily be accessed at boot time with a PC serial communications program such as Minicom on Linux
or HyperTerminal on Windows.
In our examples we will be using HyperTerminal but these procedures should be preformed easily us-
ing any terminal communications software. The illustration below shows how the communication port
should be configured.
SERIAL PORT CONFIGURATION