User's Manual

CHAPTER 8 INTERFACE CONTROL DOCUMENTS (ICD)
APPENDIX A INTERFACE CONTROL DOCUMENTS (ICD)
ISSUE/REVISION DATE: 25 JULY 2007 TECHNICAL MANUAL
ISO 9001:2000 PROPRIETARY
Interface Control Document (ICD) ENTERPRISE ELECTRONICS CORPORATION
Rev No. 5 Page 11 of 21
Issue Date 25 July 2007 UM-130365
Distribution Data Collection
Module (DDC)
THE DATA PRESENTED HEREIN REPRESENTS THE INTELLECTUAL PROPERTY OF ENTERPRISE ELECTRONICS CORPORATION (EEC). THIS DATA MAY NOT BE DISTRIBUTED OR REPRODUCED BY
ANY MEANS WITHOUT THE EXPRESS, WRITTEN CONSENT OF EEC.
2.4.2 I/O Pinouts on J4
I/O Connector J4
Pin Function Capability
1
+24 Source 1
+24VDC Switched @500ma
2 K9 Relay drive @500ma
3 Dout1 TTL output @40ma
4 Dout3 TTL output @40ma
5 Gnd
6 Dout6 TTL output @40ma
7 Dout8 TTL output @40ma
8 Din1 0-30VDC discrete input
9 Din3 0-30VDC discrete input
10 Gnd
11 Din6 0-30VDC discrete input
12 Din8 0-30VDC discrete input
13 Din9 0-30VDC discrete input
14 Din11 0-30VDC discrete input
15 Gnd
16 Din14 0-30VDC discrete input
17 Din16 0-30VDC discrete input
18 NC
19 NC
20 +24V Source 2 +24VDC Switched @500ma
21 K10 Relay drive @500ma
22 Dout2 TTL output @40ma
23 Dout4 TTL output @40ma
24 Dout5 TTL output @40ma
25 Dout7 TTL output @40ma
26 Gnd
27 Din2 0-30VDC discrete input
28 Din4 0-30VDC discrete input
29 Din5 0-30VDC discrete input
30 Din7 0-30VDC discrete input
31 Gnd
32 Din10 0-30VDC discrete input
33 Din12 0-30VDC discrete input
34 Din13 0-30VDC discrete input
35 Din15 0-30VDC discrete input
36 Gnd
37 NC
Table 7 – J4