User's Manual

CHAPTER 8 INTERFACE CONTROL DOCUMENTS (ICD)
APPENDIX A INTERFACE CONTROL DOCUMENTS (ICD)
ISSUE/REVISION DATE: 25 JULY 2007 TECHNICAL MANUAL
ISO 9001:2000 PROPRIETARY
Interface Control Document (ICD) ENTERPRISE ELECTRONICS CORPORATION
Rev No. 5 Page 10 of 21
Issue Date 25 July 2007 UM-130365
Distribution Data Collection
Module (DDC)
THE DATA PRESENTED HEREIN REPRESENTS THE INTELLECTUAL PROPERTY OF ENTERPRISE ELECTRONICS CORPORATION (EEC). THIS DATA MAY NOT BE DISTRIBUTED OR REPRODUCED BY
ANY MEANS WITHOUT THE EXPRESS, WRITTEN CONSENT OF EEC.
I/O Connector J3
Pin Input/
Output
Capability
1 AN3 10bit ADC input 0-5VDC
2 AN2 10bit ADC input 0-5VDC
3 AN0 10bit ADC input 0-5VDC
4 AN52 10bit ADC input 0-5VDC
5 Gnd
6 Gnd
7 Gnd
8 Gnd
9 +5VDC VCC
10 TrigIn1 0-30V Pulsed Input
11 TrigIn2 0-30V Pulsed Input
12 TrigOut1 15V or 5V Drive output
13 K8 Relay drive @500ma
14 K6 Relay drive @500ma
15 K4 Relay drive @500ma
16 K2 Relay drive @500ma
17 TrigOut2 5V Drive output
18 NC
19 NC
20 AN1 10bit ADC input 0-5VDC
21 AN56 10bit ADC input 0-5VDC
22 AN53 10bit ADC input 0-5VDC
23 AN55 10bit ADC input 0-5VDC
24 Gnd
25 Gnd
26 Gnd
27 Gnd
28 +5VDC VCC
29 Gnd
30 Gnd
31 Gnd
32 K7 Relay drive @500ma
33 K5 Relay drive @500ma
34 K3
Relay drive @500ma
35 K1 Relay drive @500ma
36 Gnd
37 NC
2.4.1 I/O Pinouts on J3
Table 6 – J3