Specifications

Frame Relay WAN Link with PPP Backup Sample Configuration
3-44 Software Configuration
XSR(config-controller<T1-1/0>)#no shutdown
Enables T1 controller
XSR(config)#interface serial 1/0:0
Configures Serial interface 1, port 1 using channel group 0 and acquires Interface mode
XSR(config-if<S1/0:0>)#encapsulation ppp
Enables PPP encapsulation
XSR(config-if<S1/0:0>)#ppp authentication chap
Configures CHAP authentication on the interface
XSR(config-if<S1/0:0>)#ip address 154.68.1.47 255.255.255.0
Enables IP address for serial interface 1/0
XSR(config-if<S1/0:0>)#backup interface dialer 5
Sets dialed interface as a dialed backup
XSR(config-if<S1/0:0>)#no shutdown
Enables the interface
XSR(config)#router rip
Enables RIP routing and goes to Router mode
XSR(config-router)#network 192.168.1.100
Configures a network RIP will advertise its routes to
XSR(config-router)#network 154.68.1.0
Configures a second network RIP will advertise its routes to
XSR(config-router)#network 164.55.7.0
Configures a third network RIP will advertise its routes to
XSR(config)#interface dialer 5
Adds backup interface and acquires Interface mode
XSR(config-if<D5>)#dialer pool 3
Adds a dialer pool on interface
XSR(config-if<D5>)#dialer string 18005555555
Sets backup phone #
XSR(config-if<D5>)#encapsulation ppp
Enables PPP encapsulation on port
XSR(config-if<D5>)#ppp authentication chap
Sets CHAP on port
XSR(config-if<D5>)#ip address 164.55.7.22 255.255.255.0
Enables the IP address for dialer interface 5
XSR(config-if<D5>)#no shutdown
Enables the interface
XSR(config)#interface serial 2/0
Configures backup interface: Serial card in slot 2, port 0 and acquires Interface mode
XSR(config-if<S2/0>)#dialer pool-member 3
Adds a dial pool
XSR(config-if<S2/0>)#physical-layer sync
Sets synchronous mode
XSR(config-if<S2/0>)#no shutdown
Enables the interface
Frame Relay WAN Link with PPP Backup Sample Configuration
The sample configuration below, similar to the preceding configuration except that the cloud
supporting the primary line is Frame Relay rather than Public Service Telephone Network,
configures one LAN port, the Frame Relay WAN, QoS, OSPF routing, DHCP Relay, IP broadcast
forwarding, SNMP with ACL rules, and access lists.