Specifications

Cable, CompactFlash and Accessory Specifications
A-82
CompactFlash Memory Card
The optional plug-in CompactFlash (CF) memory card, shown in Figure A-27, comprises a single
chip controller and flash memory modules in a matchbook-sized package with a 50-pin, PCMCIA
connector consisting of two rows of 25 female contacts each.
The PCMCIA male interface supports both Type I and Type II CF cards. Note that the CF release
mechanism pops out when you install the card. For installation instructions, refer to the Hardware
Installation chapter.
Figure A-27 CompactFlash Memory Card
LED Behavior
The ten LEDs located on the XSR front panel display system and port status as described in the
Table A-3 and illustrated in Figure A-28.
Figure A-28 XSR LEDs
Pin 50
Pin 1
Table A-3 LED Description
LED State Function
POWER ON 3.3V power is present
SYS(tem Status) ON/OFF XSR is operational/malfunctioning due to hardware or bootrom
problem
Blinking
slowly
Flash update is in progress (software image downloading),
warning you not to power down the XSR. Powering down now
can leave the branch router without valid software.
VPN ON/OFF VPN tunnel is connected/disconnected
ETHERNET PORT 1/2 ON/OFF 10 or 100BaseT link is auto-detected/down
Ethernet 1/2 ACT(ivity) Blinking Port is transmitting or receiving data
CONSOLE Blinking Port is transmitting or receiving data
ETHERNET
PORT 1
ETHERNET
PORT 2
SYS VPN CONSOLE NIM1 NIM2
10/100BT 10/100BT ACT
POWER
ACT