Specifications

62 VH-8G User Interface VH-8G
Configuring Static Unicast Addresses
Use the Static Unicast Address Table Configuration screen to manually
configure host MAC addresses in the unicast table. You can use this
screen to associate a MAC address with a specific VLAN ID and switch
port as shown below.
Figure 2-50. Static Unicast Addreeess Table Configuration
Vertical Horizon Local Management -- VH-8G
Static Unicast Address Table Configuration
VID MAC Address Port Status
------------------------------------------------------------------------
1 00-00-00-E8-43-12 1 Permanent
Sorted by : VID + MAC VID : 1 MAC: 00-00-00-00-00-00
VID : 1 Port : 1
MAC : 00-00-00-00-00-00 Status : Permanent
[Show] [More] [Set]
<OK>
Use <TAB> or arrow keys to move. <Enter> to select
Parameter Description
VID The VLAN group this port is assigned to.
MAC Address The MAC address of a host device attached to this switch.
Port The port the host device is attached to.
Status The status for an entry can be set to:
Permanent: This entry is currently in use and will remain
so after the next reset of the switch.
DeleteOnReset: This entry is currently in use and will remain
so until the next reset.
Invalid: Removes the corresponding entry.
DeleteOnTimeOut: This entry is currently in use and will remain
so until it is aged out. (Refer to Address Table
Aging Time on page 60.)
Other: This entry is currently in use but the
conditions under which it will remain so differ
from the preceding values.
[Show] Displays the static address table sorted on VID as the primary key
and MAC address as secondary key.
[More] Scrolls through entries in the static address table.
[Set] Adds the specified entry to the static address table, such as
shown in the following example:
VID : 1 MAC : 00-00-00-e8-34-22
Port : 1
Status : Permanent