Specifications

2 Management Overview VH-8G
In-Band Connections
Prior to accessing the switch via a network connection, you must first
configure it with a valid IP address, subnet mask, and default gateway
using an out-of-band connection or the BootP protocol.
Telnet Connection
Prior to accessing the switch via an in-band Telnet connection, you must
first configure it with a valid IP address, subnet mask, and default gateway
using an out-of-band connection or BootP protocol. After configuring the
switch’s IP parameters, you can access the on-board configuration
program from anywhere within the attached network.
In-Band Network Connection
The on-board configuration program can be accessed using Telnet from
any computer attached to the network. The switch can also be managed
by any computer using a Web browser (Internet Explorer 4.0 or above, or
Netscape Navigator 4.0 or above), or from a network computer using
network management software.
Use the Network Configuration menu to specify the
maximum number of simultaneous Telnet sessions that
are supported by the system.