Installation guide

Configure the Appliance
3-2 Configuration
6. Selectfromthefollowing,highlightOK,andpressEnter.
• staticIP:usesastaticIPaddresstoconfigureEthernet
• DCHP:usesaDHCPservertoconfigureEthernet
• loopback:usedtosetupaloopbackconnection(modemornonet)
TheENTERIPADDRESSFOR“yourhostname”screenappears.
7. EntertheapplianceIPaddress,highlightOK,andpressEnter.
TheENTERNETMASKFORLOCALNETWORKscreenappears.
8. Entertheappliancenetmask,highlightOK,andpressEnter.
TheENTERGATEWAYADDRESSscreenappears.
9. Enterthegatewayaddressforyournetwork,highlightOK,andpressEnter.
TheUSEANAMESERVER
screenappears.
10. Ifyouwillbeaccessinganameserver,highlightYesandpressEnter.
TheSELECTNAMESERVERscreenappears.
11. EntertheprimarynameserverIPaddress,highlightOK,andpressEnter.
TheCONFIRMNETWORKSETUPscreenappears.
12. Verifyyourinformation,highlightACCEPT,andpressEnter.PressEnteragainin
thesecond
verificationscreentoaccept.
Basicnetworkconfigurationiscomplete.TheENTERMANAGEMENTSERVERIPscreen
appears.
13. EntertheIPaddressofthemanagementserver,highlightOK,andpressEnter.
TheHWCLOCKscreenappears.
14. Selectthehardwareclocksetting,andthenthetimezoneconfiguration.HighlightOKand
pressEnter.
The
ENABLESNMPDAEMONscreenappears.
15. TomonitortheapplianceusinganSNMPnodemanager,highlightYESandpressEnter.
TheENTERSYSTEMCONTACTandtheENTERSYSTEMLOCATIONscreensappear.
16. Enterthesystemcontactandthesystemlocation.HighlightOKandpressEnterforeach
screen.
TheREADCOMMUNITYSTRING,WRITE COMMUNITY
STRING,SNMPTRAP
DESTINATION,andtheTRAPCOMMUNITYscreensappear.
17. Enterthereadcommunitystring,writecommunity string,SNMPtrapdestination,andthe
trapcommunitystring.HighlightOKandpressEnterforeachscreen.
18. Configurationiscomplete.Reboottheappliance.
Note: Static IP is recommended; however, you must evaluate your network environment.
Note: If you do not have a gateway on your network, leave the field blank and press Enter.