Setup guide

SmartSwitch 6A000 Installation and Setup Guide 3-9
Configuring the Switch Using the Console
To obtain an explanation of a command and its parameters, enter the word help (or ?) before the command.
SmartSwitch # ? add laneclient
Create LANE Client
============================================================================
ClientNumber Local Client Number (0-127)
LanName Name of the ELAN to join
ServerType Type of LANE Server [LECS, LES]
ServerAddress ATM Address of the LANE Server
IPAddress IP Address of the Client
NetMask IP Netmask of the Client
MTU MTU for the Client [1516, 9234, NONE]
SmartSwitch #
While entering a command, you can obtain help about the current parameter by entering a question mark (?) at the
prompt. For example:
SmartSwitch # add atmroute
PortNumber(A1) : a3
AtmAddress() : 39:00:00:00:00:00:00:00:00:00:14:72:80
PrefixLength(104) :
Index(0) :
Type(Internal) : ? — We want help on this
The type of reachability. Use Internal, Exterior, or Reject.
Type(Internal) :exterior
Scope(0) :
MetricsTag(0) :
SmartSwitch #
Note
To back out of any command, press the Esc key before entering the last value.
Note
For complete information about using you SmartSwitch ATM switch, see the
SmartSwitch ATM User Guide.