Setup guide

3-2 SmartSwitch 6A000 Installation and Setup Guide
Switch Configuration Configuring the Switch
Figure 3-1 SmartSwitch 6A000 console and network connections
5. Start the dumb terminal or PC and its terminal emulation software; then turn on the SmartSwitch
6A000 switch.
6. As the SmartSwitch 6A000 powers up, a series of diagnostic messages appears on the terminal’s
screen.
7. After the diagnostics are finished, the switch prompts for a password. Enter the default password,
“
admin.”
8. The switch prompts for the information necessary to make the switch accessible through your
Ethernet network. Supply the following information:
• Switch name
• IP address
• Subnet mask of the Ethernet network
• Default Gateway on your Ethernet network
Terminal
Ethernet
Network
Terminal
RJ-45
Port
Ethernet
RJ-45
Port
NO SYNC DATA
NO SYNC DATA
1 2 3
4
1234
IOM-21-4 IOM-22-4
NO SYNC DATA
NO SYNC DATA
1 2 3
4
1234
IOM-21-4 IOM-22-4
ATM
FAIL
STATUS
POWER
RX ENET
TX ENET
S
Y
S
T
E
M