Specifications
Startup and General Configuration Summary
Setting Basic Device Properties
SecureStack A2 Configuration Guide 2-63
2.1.12.13 set summertime date
Use this command to configure specific dates to start and stop daylight savings time. These
settings will be non-recurring and will have to be reset annually.
set summertime date start_month start_date start_year start_hr_min end_month
end_date end_year end_hr_min [offset_minutes]
Syntax Description
Command Defaults
If an offset is not specified, none will be applied.
Command Mode
Read-Write.
Example
This example shows how to set a daylight savings time start date of April 4, 2004 at 2 a.m. and an
ending date of October 31, 2004 at 2 a.m. with an offset time of one hour:
start_month Specifies the month of the year to start daylight savings
time.
start_date Specifies the day of the month to start daylight savings
time.
start_year Specifies the year to start daylight savings time.
start_hr_min Specifies the time of day to start daylight savings time.
Format is hh:mm.
end_month Specifies the month of the year to end daylight savings
time.
end_date Specifies the day of the month to end daylight savings
time.
end_year Specifies the year to end daylight savings time.
end_hr_min Specifies the time of day to end daylight savings time.
Format is hh:mm.
offset_minutes (Optional) Specifies the amount of time in minutes to
offset daylight savings time from the non-daylight savings
time system setting. Valid values are 1 - 1440.
A2(su)->set summertime date April 4 2004 02:00 October 31 2004 02:00 60