Specifications

Startup and General Configuration Summary
Configuring Switches in a Stack
2-26 SecureStack A2 Configuration Guide
2.1.10.2 show switch
Use this command to display information about one or more units in the stack. After a stack has
been configured, you can use this command to physically confirm the identity of each unit. When
you enter the command with a unit number, the MGR LED of the specified switch will blink for 10
seconds. The normal state of this LED is off for member units and steady green for the manager unit.
show switch [status] [unit]
Syntax Description
Command Defaults
If not specified, status and other configuration information about all units will be
displayed.
Command Mode
Read-Only.
Examples
This example shows how to display information about all switch units in the stack:
status (Optional) Displays power and administrative status
information for one or more units in the stack.
unit (Optional) Specifies the unit(s) for which information will
display.
A2(rw)->show switch
Management Preconfig Plugged-in Switch Code
Switch Status Model ID Model ID Status Version
------ ------------ ------------- ------------- --------------------- --------
1 Stack Member A2H124-24 A2H124-24 OK 01.00.26
2 Stack Member A2H124-24 A2H124-24 OK 01.00.26
3 Stack Member A2H124-48 A2H124-48 OK 01.00.26
4 Stack Member A2H124-24P A2H124-24P OK 01.00.26
5 Stack Member A2H124-48 A2H124-48 OK 01.00.26
6 Stack Member A2H124-24P A2H124-24P OK 01.00.26
7 Mgmt Switch A2H124-48P A2H124-48P OK 01.00.26