Specifications

Startup and General Configuration Summary
Configuring Switches in a Stack
SecureStack A2 Configuration Guide 2-25
2.1.10.1 set switch stack-port
Use this command to configure the two front panel uplink ports as standard Gigabit Ethernet ports
or stack ports.
set switch stack-port {ethernet | stack}
Syntax Description
Command Defaults
By default, the front panel uplink ports are in stack mode.
Command Mode
Read-Write.
Example
This example shows how to set the front panel stacking ports as Gigabit Ethernet ports:
NOTES: Use this command only on standalone (non-stacked) A2 switches.
Using this command will cause a switch reset.
Do not stack A2 switches with uplink ports that are in Ethernet mode.
ethernet | stack Change the two front panel stack ports to Ethernet mode
or Stacking mode.
A2(su)->set switch stack-port ethernet
This command will reset the entire system.
Do you want to continue (y/n) [n]?y
NOTE: The front panel Stacking Ports will only be displayed in the show port status command
when they are in Ethernet mode.
When the front panel uplink ports are configured in Ethernet mode the clear config command will
not change the uplink ports back to Stacking mode. The clear config all command will change the
uplink ports back to Stacking mode.