Specifications

Startup and General Configuration Summary
Configuring Switches in a Stack
SecureStack A2 Configuration Guide 2-23
A2(su)->set vlan create 555
A2(su)->clear vlan egress 1 fe.2.1
A2(su)->set port vlan fe.2.1 555 untagged
A2(su)->show port vlan fe.2.1
fe.2.1 is set to 555
Considerations About Using Clear Config in a Stack
When using the clear config command (as described in Section 2.1.19.2) to clear configuration
parameters in a stack, it is important to remember the following:
• Use clear config to clear config parameters without clearing stack unit IDs. This command
WILL NOT clear stack parameters or the IP address and avoids the process of re-numbering the
stack.
• Use clear config all when it is necessary to clear all config parameters, including stack unit IDs
and switch priority values.This command will not clear the IP address.
• Use clear ip address to remove the IP address of the stack.
Configuration parameters and stacking information can also be cleared on the master unit only by
selecting the “restore configuration to factory defaults” option from the boot menu on switch
startup. This selection will leave stacking priorities on all other units.
Using Clear Config on a Standalone A2 with the Uplink Ports Configured as
Standard Gigabit Ethernet Ports
When using the clear config command (as described in Section 2.1.19.2) to clear configuration
parameters on a standalone A2 switch with the uplink ports configured as standard Ethernet ports,
it is important to remember the following:
• The clear config command WILL NOT set the front panel uplink ports back to stack ports.
• The clear config all command WILL set the front panel uplink ports back to stack ports.
Purpose
To review, individually configure and manage switches in a SecureStack A2 stack.
Commands
The commands used to review, individually configure and manage switches in a SecureStack A2
stack are listed below and described in the associated section as shown.
• set switch stack-port (Section 2.1.10.1)
• show switch (Section 2.1.10.2)