Specifications

Security Configuration Command Set
Configuring MAC Locking
SecureStack A2 Configuration Guide 10-79
10.3.6.12 set maclock trap
Use this command to enable or disable MAC lock trap messaging. When enabled, this feature
authorizes the switch to send an SNMP trap message if an end station is connected that exceeds the
maximum value configured using the set maclock firstarrival command. Violating MAC
addresses are dropped from the switch’s routing table.
set maclock trap port-string {enable | disable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to enable MAC lock trap messaging on fe.2.3:
port-string Specifies the port on which MAC lock trap messaging will
be enabled or disabled. For a detailed description of
possible port-string values, refer to Section 3.1.1.
enable | disable Enables or disables MAC lock trap messaging.
A2(rw)->set maclock trap fe.2.3 enable