Specifications

Security Configuration Command Set
Configuring MAC Locking
10-70 SecureStack A2 Configuration Guide
10.3.6.3 set maclock enable
Use this command to enable MAC locking globally on the switch, and then on a port by port basis.
Both must be done for MAC locking to function. When enabled and configured for a specific MAC
address and port string, this locks a port so that only one end station address is allowed to
communicate on the port.
set maclock enable [port-string]
Syntax Description
Command Defaults
If port-string is not specified, then MAC locking is enabled globally on the switch.
Command Mode
Read-Write.
Examples
This example shows how to enable MAC locking on the switch:
This example shows how to enable MAC locking on fe.2.3:
port-string (Optional) Enables MAC locking on specific port(s). For
a detailed description of possible port-string values, refer
to Section 3.1.1.
A2(rw)->set maclock enable
A2(rw)->set maclock enable fe.2.3