Specifications

Security Configuration Command Set
Configuring RADIUS
SecureStack A2 Configuration Guide 10-11
10.3.1.5 set radius accounting
Use this command to configure RADIUS accounting.
set radius accounting {[enable | disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]]}
Syntax Description
Command Mode
Read-Write.
Command Defaults
None.
Examples
This example shows how to enable the RADIUS accounting client for authenticating with the
accounting server at IP address 10.2.4.12, UDP authentication port 1800. As previously noted, the
“server secret” password entered here must match that already configured as the Read-Write (rw)
password on the RADIUS accounting server
:
enable | disable Enables or disables the RADIUS accounting client.
retries retries Sets the maximum number of attempts to contact a specified
RADIUS accounting server before timing out. Valid retry
values are 1 - 10.
timeout timeout Sets the maximum amount of time (in seconds) to establish
contact with a specified RADIUS accounting server before
timing out. Valid timeout values are 1 - 30.
server ip_address
port server-secret
Specifies the accounting server’s:
• IP address
• UDP authentication port (0 - 65535)
• server-secret (Read-Write password to access this
accounting server. Switch will prompt for this entry
upon creating a server instance, as shown in the example
below.)
A2(rw)->set radius accounting server 12.12.12.1 1800
Enter secret:
Re-enter secret: