Specifications

Security Configuration Command Set
Configuring RADIUS
10-4 SecureStack A2 Configuration Guide
10.3.1.1 show radius
Use this command to display the current RADIUS client/server configuration.
show radius [status | retries | timeout | server [index | all]]
Syntax Description
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all RADIUS configuration information will be
displayed.
Example
This example shows how to display RADIUS configuration information:
Table 10-1 provides an explanation of the command output.
status (Optional) Displays the RADIUS server’s enable status.
retries (Optional) Displays the number of retry attempts before the
RADIUS server times out.
timeout (Optional) Displays the maximum amount of time (in
seconds) to establish contact with the RADIUS server
before retry attempts begin.
server (Optional) Displays RADIUS server configuration
information.
index | all For use with the server parameter to show server
configuration for all servers or a specific RADIUS server as
defined by an index.
A2(rw)->show radius
RADIUS status: Enabled
RADIUS retries: 3
RADIUS timeout: 20 seconds
RADIUS Server IP Address Auth-Port Realm-Type
-------------- ---------- --------- -----------------
10 172.16.20.10 1812 management-access