Specifications

Port Priority and Rate Limiting Configuration Command Set
Configuring Port Traffic Rate Limiting
SecureStack A2 Configuration Guide 8-19
8.3.4.2 set port ratelimit
Use this command to configure the traffic rate limiting status and threshold (in kilobytes per second)
for one or more ports.
set port ratelimit {disable | enable} | port-string priority threshold {disable |
enable} [inbound] [index]
Syntax Description
Command Defaults
• Threshold will be applied to inbound traffic on the port/priority.
• If index is not specified, settings will be applied to index 1, and will overwrite
index 1 for any subsequent rate limits configured.
Command Mode
Read-Write.
disable | enable When entered without a port-string, globally disables or
enables the port rate limiting function. When entered
with a port-string, disables or enables rate limiting on
specific port(s) when the global function is enabled.
port-string Specifies a port on which to set the rate limiting threshold
and other parameters. For a detailed description of
possible port-string values, refer to Section 3.1.1.
priority Specifies the 802.1D (802.1p) port priority level
associated with the port-string. The value can be 0 to 7,
with 0 specifying the lowest priority.
threshold Specifies a port rate limiting threshold in bytes per
second. Range is 64 up the maximum of 2,147,483,647
kilobytes per second.
inbound (Optional) Applies this rate policing rule to inbound
traffic.
index (Optional) Assigns a resource index for this port.