Specifications

Port Priority and Rate Limiting Configuration Command Set
Configuring Quality of Service (QoS)
8-10 SecureStack A2 Configuration Guide
8.3.3 Configuring Quality of Service (QoS)
Purpose
Eight transmit queues are implemented in the switch hardware for each port, but only six are
available for use in prioritizing various data and control traffic. The seventh and eighth queues are
reserved for stacking and network control related communications.
The commands in this section allow you to set the priority mode and weight for each of the available
six queues (queues 0 through 5) for each physical port on the switch. Priority mode and weight
cannot be configured on LAGs, only on the physical ports that make up the LAG.
Command Descriptions
The commands to configure the Quality of Service are listed below and described in the associated
section.
• show port txq (Section 8.3.3.1)
• set port txq (Section 8.3.3.2)
• clear port txq (Section 8.3.3.3)