Specifications

Startup and General Configuration Summary
Using and Configuring WebView
2-6 SecureStack A2 Configuration Guide
2.1.4 Using and Configuring WebView
Purpose
WebView is the Enterasys Networks embedded web server for switch configuration and
management tasks. By default, WebView is enabled on TCP port number 80 on the SecureStack A2
switch. You can verify WebView status, and enable or disable WebView, as described in the
following sections. WebView can also be securely used over SSL port 443. By default SSL is
disabled.
To use WebView, type the IP address of the switch in your browser. To use WebView over SSL, type
in https:// then the IP address of the switch. Example: https://172.16.2.10 (SSL must be enabled on
the switch first).
Commands
The commands to configure WebView and SSL are described below.
• show webview (Section 2.1.4.1)
• set webview (Section 2.1.4.2)
• show ssl (Section 2.1.4.3)
• set ssl (Section 2.1.4.4)