Specifications

SNMP Configuration Command Set
Configuring SNMP Target Addresses
4-42 SecureStack A2 Configuration Guide
4.3.6 Configuring SNMP Target Addresses
Purpose
To review and configure SNMP target addresses which will receive SNMP notification messages.
An address configuration can be linked to optional SNMP transmit, or target, parameters (such as
timeout, retry count, and UDP port) set with the set snmp targetparams command
(Section 4.3.5.2).
Commands
The commands used to review and configure SNMP target addresses are listed below and described
in the associated section as shown.
• show snmp targetaddr (Section 4.3.6.1)
• set snmp targetaddr (Section 4.3.6.2)
• clear snmp targetaddr (Section 4.3.6.3)