Specifications

Process Overview: SNMP Configuration
Using SNMP Contexts to Access Specific MIBs
4-4 SecureStack A2 Configuration Guide
4.2 PROCESS OVERVIEW: SNMP CONFIGURATION
Use the following steps as a guide to configuring SNMP on the device:
1. Reviewing SNMP statistics (Section 4.3.1)
2. Configuring SNMP users, groups and communities (Section 4.3.2)
3. Configuring SNMP access rights (Section 4.3.3)
4. Configuring SNMP MIB views (Section 4.3.4)
5. Configuring SNMP target parameters (Section 4.3.5)
6. Configuring SNMP target addresses (Section 4.3.6)
7. Configuring SNMP notification parameters (Section 4.3.7)
8. Creating a basic SNMP trap configuration (Section 4.3.8)
NOTE: Commands for configuring SNMP on the SecureStack A2 device are independent during
the SNMP setup process. For instance, target parameters can be specified when setting up
optional notification filters — even though these parameters have not yet been created with the
set snmp targetparams command. The following steps are a guideline to configuring SNMP and
do not necessarily need to be executed in this order.