Specifications

Link Aggregation Control Protocol (LACP)
Configuring Link Aggregation
3-64 SecureStack A2 Configuration Guide
3.5.4.11 set port lacp
Use this command to set link aggregation parameters for one or more ports. These settings will
determine the specified underlying physical ports’ ability to join a LAG, and their administrative
state once aggregated.
set port lacp port port-string {[aadminkey aadminkey] [aadminstate
{lacpactive | lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef |
lacpexpire}] [aportpri aportpri] [asyspri asyspri] [enable | [disable]
[padminkey padminkey] [padminport padminport] [padminportpri
padminportpri] [padminstate {lacpactive | lacptimeout | lacpagg | lacpsync |
lacpcollect | lacpdist | lacpdef | lacpexpire}] [padminsysid padminsysid]
[padminsyspri padminsyspri]
Syntax Description
port port-string Specifies the physical port(s) on which to configure
LACP. For a detailed description of possible port-string
values, refer to Section 3.1.1.
aadminkey
aadminkey
Sets the port’s actor admin key. LACP will use this value
to form an oper key and will determine which underlying
physical ports are capable of aggregating by comparing
oper keys. Aggregator ports allow only underlying ports
with oper keys matching theirs to join their LAG. Valid
values are 1 - 65535. The default key value is 32768.
aadminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync |
lacpcollect |
lacpdist | lacpdef |
lacpexpire
Sets the port’s actor LACP administrative state to allow
for:
• lacpactive - Transmitting LACP PDUs.
• lacptimeout - Transmitting LACP PDUs every 1 sec.
vs 30 sec. (default).
• lacpagg - Aggregation on this port.
• lacpsync - Transition to synchronization state.
• lacpcollect - Transition to collection state.
• lacpdist - Transition to distribution state.
• lacpdef - Transition to defaulted state.
• lacpexpire - Transition to expired state.