Specifications

Link Aggregation Control Protocol (LACP)
Configuring Link Aggregation
3-60 SecureStack A2 Configuration Guide
3.5.4.8 set lacp singleportlag
Use this command to enable or disable the formation of single port LAGs. When enabled, this
maintains LAGs when only one port is receiving protocol transmissions from a partner. If single
port LAG is not enabled, when a LAG goes down to one port, the LAG (lag.0.x) will not be used
but instead the port’s syntax will be used (for example, fe.3.24). This could cause problems if the
LAG and the port have different configurations (the LAG and the port may have different VLAN
or Policy configurations).
set lacp singleportlag {enable | disable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to enable single port LAGs:
disable | enable Enables or disables the formation of single port LAGs.
A2(su)->set lacp singleportlag enable