Specifications

Link Aggregation Control Protocol (LACP)
Configuring Link Aggregation
SecureStack A2 Configuration Guide 3-53
Table 3-4 show lacp Output Details
Output What It Displays...
Global Link
Aggregation state
Shows if LACP is enabled or disabled on the SecureStack switch.
Single Port LAGs Shows if the single port LAG feature has been enabled on the
switch. See Section 3.5.4.8 for more information about single port
LAGs.
Aggregator LAG port designation. Each SecureStack A2 unit provides 6 virtual
link aggregator ports, which are designated in the CLI as lag.0.1
through lag.0.6. Once underlying physical ports (fe.x.x or ge.x.x)
are associated with an aggregator port, the resulting Link
Aggregation Group (LAG) is represented with a lag.0.x port
designation.
Actor Local device participating in LACP negotiation.
Partner Remote device participating in LACP negotiation.
System Identifier MAC addresses for actor and partner.
System Priority System priority value which determines aggregation precedence.
Only one LACP system priority can be set on a SecureStack A2
device, using either the set lacp asyspri command
(Section 3.5.4.3), or the set port lacp command
(Section 3.5.4.11)
.
Admin Key Port’s administratively assigned key.
Oper Key Port’s operational key, derived from the admin key. Only
underlying physical ports with oper keys matching the
aggregator’s will be allowed to aggregate.
Attached Ports Underlying physical ports associated with this aggregator.
SecureStack A2 switches allow up to 4 ports per aggregator.