Specifications

Port Configuration Command Set
Setting Port Traps
3-38 SecureStack A2 Configuration Guide
3.3.7.2 set port trap
Use this command to enabled or disable ports from sending an SNMP trap message if its link state
changes (link goes up or down).
set port trap [port-string] {enable | disable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to disable link state traps for ports fe.1.1 through 4:
port-string Specifies the port(s) for which to enable or disable link state
traps. For a detailed description of possible port-string
values, refer to Section 3.1.1.
enable | disable Enables or disables a trap on the specified port.
A2(rw)->set port trap fe.1.1-4 disable