Specifications

Port Configuration Summary
Port String Syntax Used in the CLI
3-3 SecureStack A2 Configuration Guide
3.1.1 Port String Syntax Used in the CLI
Commands requiring a port-string parameter use the following syntax to designate port type, unit
number, and port number:
port type.unit number.port number
Where port type can be:
fe for 100-Mbps Ethernet
ge for 1-Gbps Ethernet
com for COM (console) port
host for the host port
lag for IEEE802.3 link aggregation ports
Unit number can be:
1 - 8 for switch units in an A2 stack
Port number can be:
1 – 52 for the A2H124-48 and A2H124-48P
1 – 28 for the A2H124-24, A2H124-24P, and A2H124-24FX
1 – 20 for the A2H254-16
The highest valid port number is dependent on the number of ports in the device and the port type.
Examples
This example shows the port-string syntax for specifying the 100-Mbps Ethernet ports 1 through
10 in unit 1 in the stack.
This example shows the port-string syntax for specifying all ports (of any interface type) in all
units in the stack.
NOTE: You can use a wildcard (*) to indicate all of an item. For example, fe.3.* would represent
all 100Mbps Ethernet (fe) ports on unit in 3 in the stack.
fe.1.1-10
*.*.*