Specifications

Startup and General Configuration Summary
Resetting the Switch
2-126 SecureStack A2 Configuration Guide
2.1.19.2 clear config
Use this command to clear the user-defined configuration parameters.
clear config [all]
Syntax Description
Command Defaults
If all is not specified, stacking configuration parameters will not be cleared.
Command Mode
Read-Write.
Example
This example shows how to clear configuration parameters, including stacking parameters:
NOTES: The switch’s IP address will be retained when running the clear config or the clear
config all command.
To clear the IP address on the SecureStack use the set ip protocol none command.
When using the clear config command to clear configuration parameters in a stack, it is important
to remember the following:
• Use clear config to clear config parameters without clearing stack unit IDs. This command
WILL NOT clear stack parameters and avoids the process of re-numbering the stack.
• Use clear config all when it is necessary to clear all config parameters, including stack unit IDs
and switch priority values.
Configuration parameters and stacking information can also be cleared on the master unit only
by selecting option 10 (restore configuration to factory defaults) from the boot menu on switch
startup. This selection will leave stacking priorities on all other units.
When an A2 standalone switch has the front panel uplink ports configured in Ethernet mode, clear
config will not change the uplink ports to Stacking mode. The clear config all command will set
the uplink ports to Stacking mode. Refer to the set switch stack-ports command,
Section 2.1.10.1, for more information.
all (Optional) Clears user-defined configuration parameters
and stack unit numbers and priorities.
A2(su)->clear config all