Specifications

Startup and General Configuration Summary
Configuring Power over Ethernet (PoE)
2-84 SecureStack A2 Configuration Guide
2.1.13.3 set inlinepower trap
Use this command to enable or disable the sending of an SNMP trap message for a unit whenever
the status of its ports changes, or whenever the module’s PoE usage threshold is crossed. The unit’s
PoE usage threshold must be set using the set inlinepower threshold command as described in
Section 2.1.13.2.
set inlinepower trap {disable | enable} unit-number
Syntax Description
Command Mode
Read-Write.
Example
This example shows how to enable PoE trap messaging on unit 1:
disable | enable Disables or enables PoE trap messaging.
unit-number Specifies the unit on which to disable or enable trap
messaging.
A2(rw)->set inlinepower trap enable 1