Specifications

Startup and General Configuration Summary
Configuring Power over Ethernet (PoE)
SecureStack A2 Configuration Guide 2-81
2.1.13 Configuring Power over Ethernet (PoE)
Purpose
To review and set PoE parameters, including the power available to the unit, the usage threshold for
each unit, whether or not SNMP trap messages will be sent when power status changes, and per-port
PoE settings.
Commands
The commands used to review and set PoE port parameters are listed below and described in the
associated section as shown.
• show inlinepower (Section 2.1.13.1)
• set inlinepower threshold (Section 2.1.13.2)
• set inlinepower trap (Section 2.1.13.3)
• show port inlinepower (Section 2.1.13.4)
• set port inlinepower (Section 2.1.13.5)
Important Notice
This section applies only to PoE-equipped SecureStack switches. Consult the Installation Guide
shipped with your product to determine if it is PoE-equipped.