Installation guide

Standards Compatibility
1-4 Introduction
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteSecureStackA2configuration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackA2ConfigurationGuide.
Standards Compatibility
The10/100BASE‐Tports,10/100/1000BASE‐T(stack)ports,and100BASE‐FXportsare
compliantwiththefollowingstandardsandoperations:
• IEEE802.3
• IEEE802.3u
• IEEE802.3ab(stackports)
• IEEE802.3ad
•Full‐Duplexoperation
• IEEE802.3xFlowControlsupportforFull‐Duplexmode
LANVIEW Diagnostic LEDs
LANVIEWdiagnosticLEDsserveasanimportanttroubleshootingaidbyprovidingan
easywaytoobservethestatusofindividualportsandoverallnetworkoperations.Refer
toChapter 4,TroubleshootingforinformationaboutusingthediagnosticLEDs.